Special Tips for Roughness Tester ARW-BT300

Home » Measurement instruments » Materials and Coatings » Roughness meters » Special Tips for Roughness Tester ARW-BT300
Special tips for the ARW-BT300 digital portable roughness meter, suitable for particular applications such as the measurement of circular and convex surfaces and grooves with a depth of up to 13mm and a width of less than 2mm
Special Tips for Roughness Tester ARW-BT300
Accessory for: Portable Roughness Gauge ARW-BT300
Product Code: ARW-KS
Availability: In Stock
  • Special tips for grooves with depths up to 13mm
  • Tips for circular surfaces with reduced curvature radii
  • Standard replacement tip
* MODEL SELECTION:

Further information

Special Tips for Roughness Tester ARW-BT-300

  • Article ARW-KS-130 (Standard probe supplied): Suitable for measurements on flat and circular surfaces with diameters greater than 50mm, Inner hole surface measurement requirements: hole diameter >5mm, hole depth <15mm
  • Article ARW-KS-110: Suitable for measurements on flat and circular surfaces with diameters even smaller than 20mm in diameter (Radius of curvature greater than 3mm), Internal hole (pipe) surface measurement requirements: hole diameter > 10mm, hole depth <15mm
  • Article ARW-KS-132: Suitable for measurements on flat, circular surfaces and grooves with a minimum width of 2mm and a maximum depth of 13mm, or the surface roughness of steps with a height <15mm
  • Article ARW-KS-133: Suitable for measurements on flat surfaces, (flat) grooves with a minimum width of 1.2mm and a maximum depth of 13mm, Or the surface roughness of steps with a height <15mm

 

© 2023 ARW Misure - Arroweld Italia S.P.A. [Via Monte Pasubio 137 - 36010 Zanè (VI) - P.IVA: 03354110243 - R.E.A.: VI/318614]